|
55 Kb |
Digitise Menus |
December 2003 |
|
| |
The AMC digitise feature enables job programs to be taught to the AMC and retained. Digitised programs may be
uploaded to a PC running GPS or JLS for editing and saving.
|
|
|
|
185 Kb |
Installation and User Guide to the Pendant handpad |
December 2003 |
| | |
The Pendant has been developed to provide a significant level of functionality remotely
from the controller. |
|
|
|
3,131 Kb |
Lockformer User Guide |
November 2001 |
| 197 Kb |
The Lockformer User Guide. The AMC4 cutter controller can control the position,
acceleration, deceleration and feedrates of up to 4 axes of motion in addition to up to 15 input signals
and 7 output signals. |
|
|
|
1520 Kb |
MC3E User Guide |
October 2001 |
|
| 46 Kb |
The MC3E has been designed to work in a wide range of configurations depending on the mechanics of the
system to which it is connected. However, it needs to be setup with the correct parameters to suit
each particular system.
|
|
|
|
1001 Kb
|
AMC RPS User Guide |
September 2001 |
|
| 51 Kb |
This Remote Programming Software can be used with the AMC controller from NEE Controls Ltd.
The software needs to be configured for use with the AMC to partially match the mechanical system you
are controlling.
|
|
|
|
1930 Kb |
AMC Cutter User Guide |
September 2001 |
|
| 152 Kb |
A guide to the AMC-4 cutter.
|
|
|
|
3,800 Kb |
AMC-B User Guide |
August 2001 |
|
| 255 Kb |
The AMC-B has primarily been designed for use without a display panel. NEE developed PC based software,
‘WinAMC®’ is generally used with the AMC-B to test, control and monitor the many powerful features
using an extended command subset.
|
|
|
|
1250 Kb |
AMC User Guide |
August 2001 |
|
| 105 Kb |
This guide is intended to be used by those unfamiliar with the AMC to obtain the basic information needed
to use the system. It is also intended as a source of detailed information for those who have experience
in using the system but need help on a particular aspect of the system operation.
|
|
|
|
115 Kb |
Installation and User Guide to the Beluga handpad |
April 2000 |
| | |
The Beluga handpad has been designed to provide the operator with the level of remote control needed
for their particular application. |
|
|
|
296 Kb |
Installation and User Guide to the AMC 4-Line Graphics Remote Keypad |
Nov 1998 |
| | |
The remote graphics keypad is an extra cost option and is similar to the standard 4-line Alphanumeric remote
handpad except that the display screen is longer and brighter providing a clearer display image.
|
|
