|
105 Kb |
Tool Setting Handpad |
November 2002 |
| | |
This booklet gives details on the handpad type and connections/signal information. It explains how to and
which parameters need to be set in the AMC configuration file, the handpad tests and of course how to
use the handpad. |
|
|
|
2,700 Kb |
MC3V HPGL User Guide |
February 1996 |
| | |
This guide details the setup and control of the MC3V, including detailed interface command descriptions,
connection details and information on how to decode errors. The MC3V accepts HPGL program data via an
RS-232 interface to a PC, the NEE Controls GPS software may be used to program it. This controller is no
longer in production.
|
|
|
|
177 Kb |
SMCU / MC3E Interface Specification |
April 1993 |
| | |
This manual details the range of commands the SMCU/MC3E controllers can accept via the serial interface.
There is additional information on serial communications, error codes, the setup of the controller and
keypad if supplied.
|
|
|
|
5,500 Kb |
MCM User Guide |
April 1992 |
| | |
The MCM machine is a stepper based controller designed for use with the DOS based control software RPS.
This guide details the setup and operation of the MCM machine showing setup commands, interface commands
and an error code details. This controller is no longer in production.
|
|
|
|
2,500 Kb |
Vinyl Cutter User Guide |
April 1991 |
| | |
This Vinyl cutter is a variant of the MC3V controller, however the machine interface is different. The
guide details interface command descriptions, connection details and general controller operation. The
machine itself was generally fitted to a roller based plotter system. This controller is no longer in
production. |
|
|
|
3,500 Kb |
PNC-4 S |
September 1990 |
| | |
The manual steps through system configuration, operation, programming and system error descriptions. The
programming section includes very good descriptions of the individual G & M codes as well as setting up
event sub-routines. This controller is no longer in production. |
|
|
|
1,050 Kb |
SMCU RPS |
July 1990 |
| | |
The RPS software is an older DOS based package which has been modified and used over the years to program
nearly all of the NEE control systems. This manual steps the user through the RPS software package, from
installing the software all the way to programming the SMCU and system error codes. The software is still
used today on some applications, still working with our most modern control systems!
|
|
|
|
1,700 Kb |
PNC-4 RPS User Guide |
June 1990 |
| | |
The RPS software is an older DOS based package which has been modified and used over the years to program
nearly all of the NEE control systems. This manual steps the user through the RPS software package, from
installing the software all the way to programming the PNC4 and system error codes.
|
|
|
|
3,340 Kb |
PNC-4 User Guide |
January 1989 |
| | |
The manual steps through system configuration, operation, programming and system error descriptions. The
programming section includes very good descriptions of the individual G&M codes as well as setting up
event sub-routines. This controller is no longer in production.
|
|
